Lumedyne, Inc.

The Straight Head Cable HC10 is about 10 feet long and has a male end that plugs towards the Power Pack and a female end that matches with the male plugs on the Flash Heads. This is a suitable way to extend the Head's built-in cable by an extra ten feet or to use a ten foot cable directly to the male plug on the Signature Series Heads.

The Straight Head Cable HCST is about 5 feet long and has a male end that plugs towards the Power Pack and a female end that matches with the male plugs on the Flash Heads. This is a suitable way to extend the Head's built-in cable by an extra five feet or to use a five foot cable directly to the male plug on the Signature Series Heads.

This coiled extension cord for the Lumedyne Heads is about 3 feet long before you start to stretch it and can easily stretch to about 7 feet. It has the silver round Head plugs at each end; one male for the Pack end and one female for the Head end. This is a direct Head Cord for the Signature Heads and an extension cord for the other Heads that have a cord already.

AFSE Flashtubes fit all of the standard Flash Heads such as the Classic #001 and #002 Heads that had no modeling light feature. They also fit the new Extra Small Basic Heads HSBC. The Flashtubes push/pull straight in/out and they will last for tens of thousands of flashes or one face down fall onto a hard surface. Any of the Heads that have a modeling light would use the AFTE instead of this one.

The Quantum™ brand Q-Flashes with an X in the Part number are designed to run from a Pack like the Lumedyne brand. In order to plug in their black four pin plug into the Lumedyne metal six pin socket, then you need an adapter like this one. It's true that Quantum™ also sells their own version of this adapter cable, however, we use a better strain relief system that helps prevent clamping the cable into a short circuit and perhaps damaging some electronics.

The ABRA replaces the normal Lumedyne reflector and has a mounting plate that allows the use of any Bowens™ style reflector or accessories. It has a 1/4-20 mounting point to keep the weight of large light modifiers off of the plastic body of the Lumedyne Heads. There is a spring clip to lock the Bowens™ style reflector/accessory in place.