Products tagged with 'lumedyne'

This is one of two diffusors that simply snap onto the silver 5" reflectors that we have made for about 45 years. This version is the more clear diffusor that will lose only 1/3 of an f-stop as it slightly softens and diffuses the light going through it. Some UV light is absorbed as well so the light is softer and warmer than when direct from the reflector.

AFTE Flashtubes fit all of the existing Lumedyne Flash Heads with or without the modeling light feature. They also fit in the new Extra Small Heads. They can be used at low power as well but should not be used above 800ws per Head as that is the upper rating of this flashtube's performance. The Flashtubes push/pull straight in/out and they will last for tens of thousands of flashes or one face down fall onto a hard surface. Any of the Heads can use this flashtube, however, the modeling lamp itself is separate and this flashtube does not convert a non-modeling Head to have that feature.

AFTQ 2400ws Quartz Flashtubes fit all of the existing Lumedyne Flash Heads with or without the modeling light feature. They also fit in the new Extra Small Heads. They can be used at low power as well and can be used up to 2,400ws as that is the upper rating of this flashtube's performance. The Flashtubes push/pull straight in/out and they will last for tens of thousands of flashes or one face down fall onto a hard surface. Any of the Heads can use this flashtube, however, the modeling lamp itself is separate and this flashtube does not convert a non-modeling Head to have that feature.

This is the normal replacement bulb for the glowing modeling light in the center of the Lumedyne Modeling style Flashtubes. It is about 25 watts bright and does use your battery at a rate of one 200ws flash per 20 seconds of modeling light use. It is user replaceable by simply first removing the flashtube then pulling the burned out bulb straight out. After carefully replacing the AMBR into its legs, the flashtube fits around it and plugs back into place.

The ARST is the normal two position Reflector that we include with most all of our Flash Heads when new. It has a hammer dimple finish on a parabolic shape that is award winning in its design in relationship to the flashtube. When it is sitting in the forward position it is normal coverage and when it drops back into the two notches, it broadcasts a wider angle.

The set of two switch caps include a red and white one for the top of the Lumedyne Power Packs. Using the switch covers helps extend the lifespan of the switch by keeping dust and debris out of it.