Lumedyne, Inc.

We manufacture everything we can in house.  We source what we can in America and we get the rest from overseas.

View as Grid List
Sort by
Display per page

AFTE 800ws Flashtube for Modeling Flash Heads

AFTE
AFTE Flashtubes fit all of the existing Lumedyne Flash Heads with or without the modeling light feature. They also fit in the new Extra Small Heads. They can be used at low power as well but should not be used above 800ws per Head as that is the upper rating of this flashtube's performance. The Flashtubes push/pull straight in/out and they will last for tens of thousands of flashes or one face down fall onto a hard surface. Any of the Heads can use this flashtube, however, the modeling lamp itself is separate and this flashtube does not convert a non-modeling Head to have that feature.
$85.00

ACAP Color Caps - Cloth covers in 7 different colors

ACAP
These colorful fabric covers are designed to fit any five to six inch reflectors and use elastic to stay on the front of the reflector. They cast a very even and smooth broadcast of colored light due to the thin cloth diffusion material. The colors can be seen in the photo as all kits are the same selection.
$85.00

BCSM Empty Small Battery Case for DIY battery

BCSM
If you want to build your own small battery this enclosure is 1.5 inches tall outside. It has the right connector to attach to the Lumedyne Power Packs. It has the keeper clips for the Pack's latches. It has a simple DC charge jack of 2.1mm by 5mm and a charging LED but no further charge control circuit or PEPI. No battery or charger is included
$80.00

BCMD Empty Medium Battery Case for DIY battery

BCMD
If you want to build your own small battery this enclosure is 2.2 inches tall outside. It has the right connector to attach to the Lumedyne Power Packs. It has the keeper clips for the Pack's latches. It has a simple DC charge jack of 2.1mm by 5mm and a charging LED but no further charge control circuit or PEPI. No battery or charger is included
$80.00

BCLG Empty Large Battery Case for DIY battery

BCLG
If you want to build your own small battery this enclosure is 3 inches tall outside. It has the right connector to attach to the Lumedyne Power Packs. It has the keeper clips for the Pack's latches. It has a simple DC charge jack of 2.1mm by 5mm and a charging LED but no further charge control circuit or PEPI. No battery or charger is included
$80.00

CX1P International Single Extra Fast Charger USA, UK, Euro & AU

CX1P
This Charger works at na Extra Fast rate from any AC wall voltage worldwide and includes plug adapters for most of the world. It charges larger Batteries very fast but is NOT recommended for the smaller sizes of Lumedyne Batteries or Cyclers. This is the "fastest" charger we offer for any batteries because it is too fast for the smaller ones already. However, some of the biggest batteries take so long to charge, so it's good to have a very fast option. This is NOT recommended for batteries older than from 2002 with serial number below 149300. If your battery is that old, contact Lumedyne directly.
$80.00