Products tagged with 'lumedyne'

This durable cloth adapter with two D-rings is designed for supporting your two piece Lumedyne Cyclers and their attached Battery by a shoulder strap since those Cyclers did not include any shoulder strap D-rings.

This is the straight silver tube that you may remember from your Flash Head box when it was new. You can use it for flashtube protection or for a simple snoot to limit the light to a very small area.

This is a simple addition to a bracket when you want to be able to aim the Head up and down. There are two adjustable disks that allow you to set the ending angle in each direction. Some set screws allow you to adjust the range of movement and it is designed to bolt onto 1/4-20 holes or use the nuts and bolts.

The name says it all, except that there is a Sharpie™ marker included if you want to make permanent notes on this flat and writable tape measure that also works with a pencil for temporary notes. If you measure the light output at a given distance before your client is in front of you, then later when you are really shooting, it's easy to always get the exact right exposure without a lot of light-meter readings and extra flashes at your subject.

The ATTE goes into a Flash Head where the Flashtube normally goes and adds about an inch to the position of the Flashtube from the face of the Head. This is generally preferred when you need a different coverage from a custom reflector than the tube provides from it's normal location.

The Quantum™ brand Q-Flashes with an X in the Part number are designed to run from a Pack like the Lumedyne brand. In order to plug in their black four pin plug into the Lumedyne metal six pin socket, then you need an adapter like this one. It's true that Quantum™ also sells their own version of this adapter cable, however, we use a better strain relief system that helps prevent clamping the cable into a short circuit and perhaps damaging some electronics.

The Straight Head Cable HC10 is about 10 feet long and has a male end that plugs towards the Power Pack and a female end that matches with the male plugs on the Flash Heads. This is a suitable way to extend the Head's built-in cable by an extra ten feet or to use a ten foot cable directly to the male plug on the Signature Series Heads.

The Straight Head Cable HC20 is about 20 feet long and has a male end that plugs towards the Power Pack and a female end that matches with the male plugs on the Flash Heads. Thats about six meters long. This is the longest cable we offer and is a suitable way to extend the Head's built-in cable by an extra twenty feet or to use a twenty foot cable directly to the male plug on the Signature Series Heads.

This coiled extension cord for the Lumedyne Heads is about 3 feet long before you start to stretch it and can easily stretch to about 7 feet. It has the silver round Head plugs at each end; one male for the Pack end and one female for the Head end. This is a direct Head Cord for the Signature Heads and an extension cord for the other Heads that have a cord already.