BLSM Small LiFePo4 Battery

The BLSM is a type of Lithium battery. It has a battery gauge right on the front of the battery. These charge up the fastest, hold their charge the best, last for the most charge cycles, have the longest pro-rate warranty and have the most flashes per pound of any of our battery options. You must use the CL3U LiFePo4 Charger but it will be finished charging up in less than an hour and a half. At 200ws this Battery provides 250 flashes per charge. BLSM Small LiFePo4 Battery is a safe style of Lithium chemistry that will not explode and is very lightweight with a lot of flashes per charge and over 2000 charge cycles.
Manufacturer: Lumedyne, Inc.

The BLSM is the smaller of the two Lithium battery options we sell.  In both cases we use LiFePo4 cells because they give the most long term performance.  These can be recharged over 2000 times and they are very safe.

We guarantee 250 flashes at 200ws with the BLSM Small LiFePo4 Battery.  It recharges very fast too.  The separate international Charger, CL3U will charge it fully in just 90 minutes.

The shell of this battery is 2.2 inches high so it resembles the Medium sized Batteries from the NiCd and NiMh style but at half the weight.  That's about a third of the weight of the Large NiCd for only 50 less flashes per charge at 200ws.

At 200ws the Battery is guaranteed to give you 250 flashes and so at 25ws that is 2000 flashes per charge.  Inversely, at 400ws this battery will give you at least 125 flashes per charge.

California customers: Proposition 65 WARNING
Product tags
Customers who bought this item also bought

AFSE 800ws Flashtube for Standard non-modeling Flash Heads

AFSE Flashtubes fit all of the standard Flash Heads such as the Classic #001 and #002 Heads that had no modeling light feature. They also fit the new Extra Small Basic Heads HSBC. The Flashtubes push/pull straight in/out and they will last for tens of thousands of flashes or one face down fall onto a hard surface. Any of the Heads that have a modeling light would use the AFTE instead of this one.

APPH Power Pack Hanger and Clamp

The APPH uses the d-rings on the Power Packs to suspend the system off the ground onto the lightstand. While this is very convenient for moving around with the gear, it's also important to keep the weight low on the lightstand rather than to need additional sand bags or ballast. The APPH can work with all generations and styles of Lumedyne Power Packs. By hanging the system it makes Battery changes easy as well.