Lumedyne, Inc.

The BMHS Battery provides 150 flashes at 200ws with a Four Year pro-rate warranty. It uses a single deck of NiMh battery cells and is about 1.5 inches tall and weighs just over a pound and a half.

The BSML Battery provides 100 flashes at 200ws with a 48 month pro-rate warranty. It uses a single deck of NiCd battery cells and is about 1.5 inches tall and weighs just under a pound and a half.

This high voltage Cycler attaches onto any of the Lumedyne Batteries which are sold separately. Photographers who need a lot of flashes per charge and want bigger batteries than what are built inside the single piece Cyclers will prefer these even though they are slightly larger, they do offer two HV output jacks so they can run two flashes even without needing a Y cable. These have a Low Battery Warning but no battery gauge. They indicate when they are recycling.

AFTE Flashtubes fit all of the existing Lumedyne Flash Heads with or without the modeling light feature. They also fit in the new Extra Small Heads. They can be used at low power as well but should not be used above 800ws per Head as that is the upper rating of this flashtube's performance. The Flashtubes push/pull straight in/out and they will last for tens of thousands of flashes or one face down fall onto a hard surface. Any of the Heads can use this flashtube, however, the modeling lamp itself is separate and this flashtube does not convert a non-modeling Head to have that feature.

This Charger works at na Extra Fast rate from any AC wall voltage worldwide and includes plug adapters for most of the world. It charges larger Batteries very fast but is NOT recommended for the smaller sizes of Lumedyne Batteries or Cyclers. This is the "fastest" charger we offer for any batteries because it is too fast for the smaller ones already. However, some of the biggest batteries take so long to charge, so it's good to have a very fast option. This is NOT recommended for batteries older than from 2002 with serial number below 149300. If your battery is that old, contact Lumedyne directly.

The ASC1 is the short coiled sync cord that would plug from the round sync jack on many professional cameras to the household sync jack on many Lumedyne Flash Heads. It is about two feet long before stretching the coils out and could reach almost five feet (but might not shrink back all the way if stretched too far).