Lumedyne, Inc.

The set of two switch caps include a red and white one for the top of the Lumedyne Power Packs. Using the switch covers helps extend the lifespan of the switch by keeping dust and debris out of it.

This is the normal replacement bulb for the glowing modeling light in the center of the Lumedyne Modeling style Flashtubes. It is about 25 watts bright and does use your battery at a rate of one 200ws flash per 20 seconds of modeling light use. It is user replaceable by simply first removing the flashtube then pulling the burned out bulb straight out. After carefully replacing the AMBR into its legs, the flashtube fits around it and plugs back into place.

AFTE Flashtubes fit all of the existing Lumedyne Flash Heads with or without the modeling light feature. They also fit in the new Extra Small Heads. They can be used at low power as well but should not be used above 800ws per Head as that is the upper rating of this flashtube's performance. The Flashtubes push/pull straight in/out and they will last for tens of thousands of flashes or one face down fall onto a hard surface. Any of the Heads can use this flashtube, however, the modeling lamp itself is separate and this flashtube does not convert a non-modeling Head to have that feature.

AFTQ 2400ws Quartz Flashtubes fit all of the existing Lumedyne Flash Heads with or without the modeling light feature. They also fit in the new Extra Small Heads. They can be used at low power as well and can be used up to 2,400ws as that is the upper rating of this flashtube's performance. The Flashtubes push/pull straight in/out and they will last for tens of thousands of flashes or one face down fall onto a hard surface. Any of the Heads can use this flashtube, however, the modeling lamp itself is separate and this flashtube does not convert a non-modeling Head to have that feature.

The ASC1 is the short coiled sync cord that would plug from the round sync jack on many professional cameras to the household sync jack on many Lumedyne Flash Heads. It is about two feet long before stretching the coils out and could reach almost five feet (but might not shrink back all the way if stretched too far).

The ASC5 is the long straight sync cord (30 feet is about 9 meters) that would plug from the round sync jack on many professional cameras to the household sync jack on many Lumedyne Flash Heads. It's perfect as a back up option to radio slaves when you want an off camera light and you have a PC sync connection or adapter on your camera.