The Chargers are available to recharge the batteries. The NiCd and NiMh batteries share most of the chargers with full compatibilty. But, the Lithium LiFePo4 batteries must use the special Lithium Charger so these have a special charge plug to prevent you from making a mistake.
All of our current chargers are international voltage compatible, it was not always that way so be aware if using outside them of America.
The Chargers that we offer today are made for the modern batteries built since 2002 with serial numbers higher than 149300. The batteries made before that time may not stop charging correctly with a modern style charger. Contact Lumedyne directly if you have Classic Batteries with lower serial numbers than that.
This is the only automatic Lumedyne Charger that will charge the battery first and also cycle on automatically each day to top off the Battery (or Batteries with the CU4A Adapter). This way the connected Battery(ies) are always ready to go without having to "top them off" before a shoot.
This is an Ultra fast charger and stops charging based on a Delta Voltage technology rather than using the PEPI circuit in the battery. This Charger is compatible with all generations of NiCd and NiMh Batteries and is designed to keep the Lumedyne Batteries fresh and ready for the longest possible lifespan.
DO NOT USE WITH LIFEPO4 BATTERIES or DIY Batteries - while it should not release the "magic" smoke, it would not work correctly for sure...
The CU4A mounts on top of the CU1Z Charger to expand its single Battery capacity into four Batteries at once. This Adapter is not a charger by itself but does work with the Auto Charger to allow up to four Batteries to be automatically maintained and topped off without having to swap Batteries around.
The CU4A does have two helpful indicators that show that the Batteries connected did reach a full charge level and another that warns you if a bad Battery is plugged into one of the connectors.
The name says it all because this gizmo does it all... Plug it into a cigarette lighter 12V DC jack in your car, truck, RV or drone and it can recharge Batteries or run Lumedyne Power Packs.
Plus, if that were not already enough, it has a separate Battery Gauge and 6 pin connector that works independent of power to test Batteries.
It's small, lightweight, versatile, and capable. Plus, with a 20 foot cable it is able to reach beyond your front seats when you want it to.